LED indicator for Port 1. From the Platform menu, select your operating system. Tape drive, SCSI bus or fibre channel error. Downloadable files Abstract Drive firmware only – there is no other updatable firmware in this product. From the Select from Tape systems menu, select Tape drivers and software. LED indicator for drive status.

Uploader: Nataxe
Date Added: 4 July 2010
File Size: 51.89 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 40915
Price: Free* [*Free Regsitration Required]

Click Continue to go to the Select fixes page. From the Platform menu, select your operating system.

Installing the IBM tape driver for Windows

The tape drives in the library are powered on. For the most recent tape drive for Windows, see Required software. View the list of available downloads. Downloadable files Abstract Drive firmware only – there is no other updatable firmware in this product. Select ” Tape Drive”. There are a few pull down menus to ultrihm-hh3 to the correct download as follows: Tape drive or RS error. Tape drive detected that the Drive Power Supply is approaching the specified voltage limit drive is still operating or is outside the specified voltage range drive is not operating.


The IBM tape device driver has two installers: If the Fix Central Link above does not work ultrium–hh3 go to: Select a download from the options presented, and click Continue. These firmware updates are ultrium-yh3 to, among other things, increase overall reliability, improve tape handling, further reduce any possibility of data errors, and provide continued enhancements to diagnostic capabilities.

The rear panel of LTO 5 and later tape drives has a power beacon LED that indicates the drive is powered on when green. Front view of the LTO 3 tape drive.

LED indicator for drive status. An easier way to obtain information about a drive error is to determine which drive is reporting an error, then access the error log for that drive by using the operator panel or by using the Tape Library Specialist web interface. While the TS tape library is active, ultrrium-hh3 can be difficult to see the SCD without opening the library door.

Platform Independent Software edition: From the Product Group menu, select System Storage. No error or message is assigned. The Unload button on the drive was pushed in and did not release.

Use one of the ultriu-mhh3 procedures, Find product or Select product, to access the IBM Fix Central portal and download the most recent version of the tape device driver. See the Setup, Operator and Service Guide for the Ultrium tape product for detailed installation instructions.


Contact and feedback Need support? See additional Firmware Installation Instructions below in the Documentation section in the table below. LED indicator for Port 0.

Downloading the IBM Tape Diagnostic Tool

Document information More support for: Supported Operating Environments This tape drive works with the following operating systems: The server is powered on. This section lists error codes that can appear on the single-character display SCD of the LTO tape drives and describes each error. Tape drive hardware problem.

D No error or message is assigned. Watson Product Search Search.

The tape drive is powered on. You can access a drive error log from the operator panel by using the Service and Drive Error Logs menus.

Author: admin